E4 CAME — Safety Edge / Contact Strip Fault
At a glance
- Severity
- FAULT STOP
- Domain
- GATE_GARAGE_AUTOMATION
- Reference standard
- EN 12453 / EN 12978
What it means
The safety edge is in alarm or faulty: the gate will not close or reverses immediately. A deformed or compressed-stuck edge, a crushed or interrupted cable, or a wireless edge transmitter with a flat battery are the first checks.
Probable causes
- Safety edge deformed or damaged
- Safety edge cable interrupted or crushed
- Wireless safety edge transmitter module battery low
- Mechanical safety edge stuck in compressed position
Full guided diagnosis in the app
The diagnostic tree for this fault has 9 guided steps with measurements, checks and resolutions. You'll find it in BASIQ, one of the five IndexOS apps: free, works offline.
Printable sheet + CAME updates
Leave your email: get the link to the printable CAME error-code sheet and a heads-up when we add new codes and guides.
Double opt-in, zero spam, one-click unsubscribe.
The same fault on other brands
More CAME codes
- E1 — Limit Switch Fault / End of Travel Error
- E1 — Travel Calibration Error / Calibration Not Completed
- E10 — Obstruction Detected During Opening
- E11 — Consecutive Obstruction Limit Exceeded
- E12 — Line Voltage Absent
- E14 — Serial Communication Error (Board to Board)
- E16 — SLAVE Barrier Cabinet Door Open (Paired Mode)
- E17 — Wireless System Not Communicating